📍 Local Job Near You
Tig Welder (1st & Swing Shift)
First Tek, Inc.
📍
Kent, Washington, United States
Location
Kent, Washington
Posted
May 16, 2026
Commute
Local Area
Local Opportunity Near You!
This job is in your area. Enjoy a short commute and work close to home.
Job Description
MUST BE US CITIZEN
DIRECT HIRE - 4 OPENINGS (1ST AND SWING SHIFT)
AEROSPACE TIG WELDER- Entry Level
2 swing shifts and Two day shifts available
4/10s (Mon-Thurs)
Schedule: Swing: 2:30pm 1am, (10-hour shifts Mon - Thurs)
Schedule: Day shift could vary but likely an early start at 3:30am or 4am (10-hour shifts Mon- Thurs).
Pay Rate Range - *** will NOT pay at the top of the range:
Welder 1 - *** - ***
MUST HAVE WELDING TECHNOLOGIES DEGREE
Entry level candidates should have their Welding Technologies degree or other weld certificate. Schools that we have seen success with include Lake Washington, South Seattle, Green River.
" We primarily do TIG welding. Welding is typically done on titanium and nickel alloys that are 30-80 though very thin.
Level 1: Applies basic welding processes to join sheet metal aircraft components as specified by written instructions, weld schedules and drawings....
DIRECT HIRE - 4 OPENINGS (1ST AND SWING SHIFT)
AEROSPACE TIG WELDER- Entry Level
2 swing shifts and Two day shifts available
4/10s (Mon-Thurs)
Schedule: Swing: 2:30pm 1am, (10-hour shifts Mon - Thurs)
Schedule: Day shift could vary but likely an early start at 3:30am or 4am (10-hour shifts Mon- Thurs).
Pay Rate Range - *** will NOT pay at the top of the range:
Welder 1 - *** - ***
MUST HAVE WELDING TECHNOLOGIES DEGREE
Entry level candidates should have their Welding Technologies degree or other weld certificate. Schools that we have seen success with include Lake Washington, South Seattle, Green River.
" We primarily do TIG welding. Welding is typically done on titanium and nickel alloys that are 30-80 though very thin.
Level 1: Applies basic welding processes to join sheet metal aircraft components as specified by written instructions, weld schedules and drawings....